SaltDogg 3008046 Vibrator Kit - Manual

www.buyersproducts.com
Phone (440) 974-8888
Fax 800-841-8003
HOPPER
2
4 5
1
12
7
11
12 VOLT
BATTERY
Installation Instructions
3008046 Vibrator Kit
Bill of Materials
1 3007416 1 Vibrator 200 Lbs 12 VDC
2 3008043 1 Plate, Vibrator Kit SST
3 3008042 1 Bracket, Switch, Vibrator
4 – 4 Screw, HX HD Cap 3/8-16x1-1/2 SST
5 – 4 Nut, Nylock 3/8-16x7/16 SST
6 – 2 Screw, Sheet Mtl #12x3/4 Hex Washer Hd SST
7 3008041 1 Switch, Vibrator Kit 200 Lbs
8 3008037 2 Terminal Push on 1/4 Female 16-14 AWG
9 3008038 2 Terminal Push on 1/4 Male 16-14 AWG
10 3008040 1 In-line Fuse 15 Amp
11 3008049 1 Grommet 3/8 Hole 3/16 Groove
12 3008044 1 Wire Harness, Vibrator Kit
13 3008039 2 Terminal Push On 1/4 Female 12-10 AWG
ITEM PART NO. QTY. DESCRIPTION
Fig. 1
WARRANTY
Buyers Products Co. warrants all truck/trailer hardware manufac-
tured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment.
Parts must be properly installed and used under normal conditions.
Any product which has been altered, including modification, mis-
use, accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of Buyers
Products Co. under this warranty is limited to repairing or replacing any
part or parts which are returned, prepaid, and are found to be defective
by Buyers Products Co. Authorization from Buyers Products Co. must
be obtained before returning any part. No charges for transportation
or labor performed on Buyers’ products will be allowed under this
warranty.
Fig. 2
CAUTION
Do not route close to exhaust system or engine.
WARNING
Do not use with sheet metal hoppers.
1. Locate the vibrator approximately 6" to 8" from the top
of the throat entry.
Note: vibrator location can be different based on size
and shape of the hopper.
Mark the mounting holes and drill four 3/8" clearance
holes in the hopper.
2. Align the Plate with the 3/8" holes inside the hopper
and put the 3/8" x 1-1/2" bolts through the plate and the
hopper.
3. Use the four nuts provided to secure the vibrator in place.
4. Disconnect vehicle electrical system from the battery.
5. Route wire harness from the vibrator to the vehicle’s
battery.
6. Drill a 3/8" hole in the fire wall. Install the rubber grom-
met provided in the hole and route wire harness through
the hole.
7. Install an inline fuse on the positive lead from the battery.
8. Find suitable location and install switch bracket and
switch. Connect switch into same lead (positive) as in-line
fuse.
9. Attach suitable terminals, based on your battery config-
uration (not included in kit) to wire harness.
10. Connect wire harness to vibrator.
Notice: Vibration is a destructive force and may damage
some hoppers. Use this product at your own risk.
3008203 Rev. B