SaltDogg WB200B v.2 - Manual (Page 5)

5
TM
RIB SIDE MUST
FACE AWAY FROM
LARGE GEAR
SHIM WASHERS
COTTER PIN
M6x40
(WITH LARGE
WASHERS)
MOUNT
TO HOLES
IN FRAME
11
M6x45
Shim
Washer
Cotter Pin
M6 Nut
12
5. Mount the Drive Wheel(11) to the Axle using a m6x45
bolt. Mount the Coast Wheel(12) using shim washers
and a cotter pin. Tighten the entire axle assembly as
shown.
A. Make sure the Bushings are fully seated against
the Frame
B. The Coast Wheel side should have only a small
gap between the outside Shim Washer and the
Cotter Pin
DRIVE WHEEL(11) HAS A HOLE THROUGH THE HUB
USED TO MOUNT TO THE AXLE WITH A M6x45 BOLT