Maple Systems HMI5000 Series - Manual

1 HMI5000 Series Installation Guide
1010-1005 Rev 05 www.maplesystems.com
Introduction
Thank you for purchasing a Maple Systems HMI5000 Series graphic
operator interface terminal (OIT). The HMI5000 Series touchscreens are
configured using the EZware-5000 software (purchased separately) and
include the following models: HMI5043N/T, HMI5056N,
HMI5070NH/TH/ETH, HMI5100N/T, HMI5104TH, HMI5104XH,
HMI5121X, and HMI5150X. This booklet describes the steps necessary
for installing the HMI5000 Series touchscreens.
For information on programming and configuring the HMI, please refer
to the HMI5000 Series Programming Manual available on the EZware
software CD. For additional information, please refer to the Support
Center section on our website, www.maplesystems.com. The Support
Center provides links to manuals, FAQs, technical notes, training videos,
sample projects, controller information sheets, and controller cables.
Static Awareness
Do NOT remove the rear cover of your HMI5000 Series product – doing
so will void your warranty. When the rear cover is removed the circuitry
inside is exposed to possible damage by electrostatic discharge during
handling. Minimize the possibility of electrostatic discharge by:
HMI5000 Series
Installation Guide