Proface FP3900 - 19 Flat Panel" - Manual (Page 8)

-8-
3 Installation
You can use the Rear Cover in combination with the Desktop Stand,
the Wall Mount Adaptor, or a commercially available arm. The in-
stallation procedures are described below.
• When attaching the Unit to the Desktop Stand
After attaching the Rear Cover to the Unit, attach the Desktop
Stand to the Unit.
• When attaching the Unit to an Arm (Commercial Type)
After attaching the Rear Cover to the Unit, attach the Unit to the
arm.
For the procedures to install the Wall Mount Adaptor, refer to its
“Wall Mount Adaptor Installation Guide”.
„ „ „ „ „ Attaching the Rear Cover
1) Remove the power supply terminal block plastic cover, expansion
unit I/F covers (EXT1 and EXT3), and the Unit's installation
gasket.
Expansion unit I/F cover (EXT1)
Power Supply Terminal Block
Plastic Cover
Expansion unit I/F cover (EXT3)
• Installing the Rear Cover while power is supplied to the Unit
may lead to an electric shock. Prior to installing the Rear Cover,
confirm that the Unit's power supply is disconnected.
• Be sure to wear gloves, to prevent cuts or abrasions.
WARNING