Asante Technologies Intrachassis 9000 - Manual (Page 113)

VLAN Management
Page 5-15
The management operations allowed on a VLAN group are:
❑ Creation
❑
Deletion
❑ Name configuration.
❑ VID Change configuration.
❑
Adding and deleting port members
❑ Adding and deleting untagged sets
❑
Sharing and unsharing VLANs
❑ Inserting and removing MAC addresses
❑
Toggling Management Access
Default VLAN
As per IEEP802.1Q specifications, the only VLAN that exists by default in the
IntraChassis 9000 is the default VLAN, with VID = 1, and all ports as its
members. Also, all ports belong to the default VLAN’s untagged set. The
following table summarizes the Default VLAN configuration in the
IntraChassis 9000.
Table 5-2 Default VLAN information and operations
Port VLAN ID
Port VLAN ID or PVID is used for VLAN classification of incoming untagged
frames and has meaning only when a port is configured to receive both
untagged and tagged frames. The untagged frames get classified to the VLAN
represented by the PVID of the ingress port and the tagged frames get classified
to the VLAN represented by the VID carried in the tag header of the received
Default VLAN Information Operations Allowed for Default VLAN
Name: Default VLAN
VID: 1
Port Members: All ports
Untagged Set: All Ports
Port PVID: 1 for all Ports
Management Access: Enabled Creation/Deletion: Not allowed
Set VLAN Name: Allowed
Change VID: Not allowed
Port member Addition/Deletion: Allowed
Untagged member Addition/Deletion: Allowed
MAC address Insertion/Removal: Allowed
Toggle Management Access: Allowed
Share/Unshare VLAN: Allowed
GLXY9.book Page 15 Thursday, February 17, 2000 3:04 PM