Watlow ANASOFT - Manual (Page 19)

Installation
ANASOFT User’s Guide 9
Number of loops
* For SYSTEM 32, loop numbers greater than 32 are data acquisition
channels only, and cannot be used as control loops.
** In CLS controllers, the last loop is a pulse control loop.
ANASOFT displays the loops with system numbers. The system loop
numbers associated with the controller loops are indicated in the
installation program as the Begin Loop and End Loop for each
controller.
Directory Paths
Job/Parameters path
This is the path to the disk directory containing the Job and System
Parameters Data Files. The path would normally be:
B:\ANASOFT\ or .\ current directory (If the system files are on drive B)
C:\ANASOFT\ or .\ current directory (If the system files are on the
hard disk). Notice that the last “\” is added automatically.
Data logging path
This is the path to the disk directory containing the LOTUS or text
[ASCII] data logging files generated by ANASOFT. This directory must
exist before running ANASOFT and turning on data logging.
B:\ANASOFT\DATALOG\ (for floppy disks)
C:\ANASOFT\DATALOG\ or.\DATALOG\ (for hard disks). Notice
that the last “\” is added automatically.
controller’s type
Number of
loops
8LS 8
12LS 12
SYSTEM32* 16 or
32 or
48 or
64
16MLS 17
32MLS 33
4CLS** 5
8CLS** 9
16CLS** 17