Watlow MINICHEF Deep Fat Fryer Application - Manual (Page 56)

5 4 ■ Wa t l o w M i n i C h e f 2 0 0 0 A p p l i c a t i o n 1 4
Event outputs
Event output 1 assists in controlling pressure.
Event output 1 will switch on when a menu starts and switch off when the time remain-
ing is equal to the value programmed in the Configuration Mode under [Etype] /
[PtinE].
If a menu is cancelled, Event output 1 switches off immediately.
Cancel a menu
Canceling a menu stops the controller operation completely. The controller does not
maintain set point temperatures or run time. Users may cancel a menu in order to run
another one, to stop menu operation for any reason, or when preparing to shut off the
fryer.
• Press the active Start/Stop key for 2 seconds.
Heat outputs will switch off. Heat output indicator lights will switch off. Event 1 also
switches off, releasing pressure. The display presents [`idle] or the time of day will
appear on the display.
Change menus or restart
With the controller in idle, select a menu as shown earlier, and press the Start/Stop key.
Temperature Alarms
The controller will alert you to temperature alarm conditions if they occur. If an alarm
occurs, take action as determined by your supervisor. See the Appendix in the Hardware
& Software Setup Guide for a Troubleshooting Chart and a summary of temperature
alarms.
Errors
The controller will alert you to errors if they occur. Errors are critical problems that
shut down the unit. If an error occurs, an error message will appear on the display. You
should switch off the power and call for service.
See the Appendix in the Hardware & Software Setup Guide for a Troubleshooting Chart
and a summary of errors.