Watlow Relay Interface Board User Manual
Relay interface board user’s guide, Watlow controls
Advertising
Table of contents
Document Outline
- Cover
- Relay Interface Board Installation Guide
- Introduction
- System Requirements
- Hardware Requirements
- Installation
- Tools Needed
- Mounting
- 1. Choose a mounting location large enough to accommodate the RIB, the I/O board or boards, the r...
- 2. Place the RIB in a suitable location to be mounted and use a pencil to trace around the plasti...
- 3. Drill and tap #6-32 holes in the marked locations.
- 4. Place the Relay Interface Board in the mounting location and insert the #6 screws in the plast...
- 5. Tighten the screws.
- Figure 1 Relay Interface Board
- Wiring
- Applying Power
- Testing Your System
- Controller Connections