Watlow Series 988 Family - Manual (Page 39)

Name Description Read (?) and/or Write (=) Syntax Range
data.1 data.2
Modbus
Address
Ramping Controller Prompt Table 981,
982,
983, 984
Command Summary Series 981-984, Chapter 5 Data Communications with the Watlow Series 988 Family 5.11
Table 5.11 -
SP1 to TOUT
ç
CAUTION:
Avoid writing <=>
continuously, such
as ramping set
points or repetitive
loops, to the
Series 981-984
EEPROM memory.
Continuous writes
may result in
premature control
failure, system
downtime and
damage to pro-
cesses and
equipment.
NOTE:
The number of
decimal places
returned by many
of these com-
mands is deter-
mined by the DEC1
or IN1 setting.
(This does not
apply to Modbus
Protocol.)
SP1 Set Point 1 ? <sp> SP1 <cr> RL1 to RH1
300 = <sp> SP1 <sp> data.2 <cr> Default: per IN1 and hardware
set SP1 to RL1-1 to turn all outputs off
SHYS Slidwire ? <sp> SHYS <cr> 0 to Hunt
1904 Hysteresis = <sp> SHYS <sp> data.2 <cr>
STP Program a File Step. ? <sp> <STP> <sp> <FILE> <cr>
Read: This key command = <sp> <STP> <sp> <FILE> data.2 <sp> ... data.n <cr>
1201 programs or queries
Write: all step information See Key Command, "STP," at
1250 for all step types: the end of this chapter for full
• Set Point (time) syntax and data. See p. 5.14
• Set Point (rate)
• Soak
• Jump-loop
• Link File
• End
STRT Start a File = <sp> STRT <sp> data.2 <sp> data.3 <sp>
1250
data.2 data.3
1 = File 1 1 = Step 1
2 = File 2
2 = Step 2
3 = File 3 3 = Step 3
4 = File 4 4 = Step 4
5 = Step 5
6 = Step 6
TOUT Test Outputs = <sp> TOUT <sp> data.2 <cr> 0 = All off
1514 1 = Output 1 on
2 = Output 2 on
3 = Output 3 on
4 = Output 4 on