Watlow Series 988LF - Manual (Page 45)

Factory Menus, Chapter 6 WATLOW Series 988LF Users Manual 6.5
❶ Press the Up-arrow > and Down-arrow
< keys together and hold until the [`LOC]
prompt appears in the lower display. Press
and hold again until the [Fcty] prompt
appears in the lower display.
❷ Use the Up-arrow key > to select the
Calibration Menu [`CAL] in the upper
display.
❸ Press the Mode key µ to step through
the prompts.
❹ Press the Up-arrow key > or the Down-
arrow key < to select one of the prompt
values.
Refer to Calibrating Watlow Process Controls
for information about the Calibration Menu.
Reaching the Calibration Menu
[diAg] [`CAL]
[Fcty] [Fcty]
Diagnostics Calibration
Menu Menu
p. 6.1 p 6.5
[``no] [`YES]
[`rSt] [`rSt]
Figure 6.5 -
The Calibration Menu
ç
CAUTION:
Before attempting to calibrate, make sure you have the
proper equipment called for in each procedure. The
Series 988LF is calibrated and tested before it leaves
the factory. Attempting to calibrate the controller
without the proper equipment could result in damage
to property and/or equipment.
Factory-Calibration
MODE
Diagnostics Prompt Document your sett
from the controller's
upper display.
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
[`CAL]]
[Fcty]
[A`50]
[A`00]
[``tc]
[a`0H]
[A`20]
[A`15]
[A380]
[A10U]
[A`0U]
[A20A]
[A`4A]
[A`OU]
[A100]
[b`50]
[b`00]
[[b`0H]
[b`20]
[b`15]
b380]
[b10U]
[b`0U
[b20A]
[b`4A]
[b`0U]
[b100]
[1`4`]
[1`20]
[1`0`]
[1`10]
[`rSt]
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
Restore
[`rSt]
Restore
Restores the original factory calibration values. This is a simple way to
recover from a mistake made while calibrating the controller.
[`rSt] This prompt always appears.
Default
↓
[``no] [`yes]
[`rSt] [`rSt]