Watlow Series F4P - Manual (Page 7)

Wa t l o w S e r i e s F 4 P O p e r a t i n g f r o m t h e F r o n t P a n e l ■ 2 . 1
Chapter Two: Navigation and
Operating from the Front Panel
Displays and Indicator Lights . . . . . . . . . . . . . . . . .2.2
Guided Programming . . . . . . . . . . . . . . . . . . . . . . .2.3
Custom Main Page . . . . . . . . . . . . . . . . . . . . . . . . .2.3
Auto and Manual Operation . . . . . . . . . . . . . . . . . .2.3
Troubleshooting Alarms and Errors . . . . . . . . . . . . .2.4
Figure 2.1 — Page Navigation.
Main Page_____
Input 1 Error
Input 2 Error
Input 3 Error
Alarm 1 Condition
Alarm 2 Condition
Tune Status 1
Input 1 Value
In 1 ■■■■
Input 2 Value
Set Point 1
Set Point 2
Digital Set Point
Power 1A
1A% ■■
Power 1B
1B% ■■■
Digital Ins 1234
Active PID Set
Message 1
Message 2
Message 3
>Go to Operations
Go to Setup
Go to Factory
Operations Page
Autotune PID
Edit PID
Alarm Set Point
PID Crossover
Ramp to Set Point
Control Set Points
Setup Page
System
Analog Inputs
Digital Inputs
Control Outputs
Alarm Outputs
Retransmit Outputs
Communications
Custom Main Page
Static Message
Factory Page
Set Lockout
Diagnostic
Test
Calibration
The Main Page presents
error messages, static
messages and the status
of inputs, outputs and
depending on the Custom
Main Page, parameter
settings in the Setup
Page.
Scroll to the bottom of the
Main Page to reach the
other pages.
When you exit the Setup
or Factory Page, the
controller prompts you to
restore the old settings or
save the new ones.
Series F4P software is organized into four sections called
“pages.” The Main Page is the central, default page that
displays status information on the lower display. To get
to the other pages, you must begin in the Main Page. ✔ Note: Access to the software is limited while the con-
troller is autotuning (Setup and Factory pages are not
accessible).
2