Watlow SpecView from Watlow - Manual (Page 32)

SpecView from Watlow  32  Watlow Addendum
2) With SpecView
running, to enter the
configuration mode,
from the File menu
choose
Configuration Mode.
3) Click to open the
Variables list.
4) Select the instrument.
5) Click Properties.
6) In the Address field
set the decimal places
corresponding to the
controller setting
0 for whole numbers,
1 for tenths,
2 for hundredths,
3 for thousandths
4 for ten-thousandths:
• For Modbus RTU
protocol set the
number after the
comma.
• For Modbus TCP or
Anafaze/AB protocols
set the number after
the second comma.
7) Click Rename Only.
Modbus RTU: the decimal setting is after the comma
Modbus TCP: the decimal setting is after the second comma
8) To save the GDW:
• From the File menu,
choose Save.
Note: The possible decimal settings may depend on other controller settings such as the sensor type.
Not all parameters are affected by the decimal setting.