Atek electronic Multimedia Remote Control - Manual (Page 10)

Special Applications
Using One Tote-Remote to Control Multiple Computers
One Tote-Remote can be used to control multiple
computers. Each computer must have its own receiver.
You will need to follow the instructions on page 5 of this
User’s Manual for using the reset button on each receiver to
learn the ID code of the remote control. The receivers will
then all use this same ID code to receive signals from the
remote control. To change the ID code again, simply follow
the same procedure again.
Using Multiple Tote-Remotes with One Computer
Since a receiver can only operate on one ID code at a time,
all the remote controls would have to be set to the same ID
code in order to control one receiver. Although you can
randomly reset your Tote-Remote’s ID code (see Trouble-
Shooting section), there is no way to set the Tote-Remote
ID code to a specific ID code. Therefore, the only way you
could use two (or more) remote controls with one receiver is
if by unlikely chance you bought two remote controls that
were set in the factory to the same ID code or if you
randomly reset one remote control to the same ID code as
another remote control. Both scenarios are highly unlikely.
9