Pfister F-534-7CMS - Manual (Page 2)

E
N
G
L
IS
H
ENGLISH
ENGLISH
4
2
3 HOLE INSTALLATION
3
5
6
Thank you for purchasing this Price Pfi ster product. All Price Pfi ster products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfi ster
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3 TOOLS RECOMMENDED
• Plumber's putty • Philips head screwdriver • Pliers
• Adjustable wrench • Flashlight • Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included:
A Faucet Body B Spray Head C Pull-Out Hose
D Quick Connector E Putty Plate F Deckplate
G Wing Nuts (2x) H Deck Metal Washer J Deck Rubber Washer
K Locknut L Lock Washer M Weight
N Mounting Ring
If any of these items are missing, please contact Price Pfi ster Consumer Services at
1-800-Pfaucet (1-800-732-8238).
6 THREE HOLE WITH DECKPLATE INSTALLATION
Place a bead of plumber’s putty in the bottom groove along the outer edge of the Putty
Plate (6A). Place Metal Washer (6B) and Rubber Washer (6C) over center hole of sink
and into the center hole of Putty Plate (6A). Ensure that Plastic Putty Plate (6A) is
pressed on to Deckplate (6D). Install Deckplate (6D) over the three holes on the sink.
Retract Pullout Hose (6E) up through Faucet Body (6F), until the pullout hose fi tting is
fl ush with the bottom of Mounting Shank (6G). Insert Faucet Supply Tubes (6H) and
Mounting Shank (6G) through the hole in Deckplate (6D).
Note: Do not feed the pullout Hose (6E) back down through the spout yet.
These instructions cover two different
installations
2
A
B
C
D
E
F
H
G
J
K
L
M
N
BOTTOM GROOVE
Go To Go To
Step 8 Step 8
Option 2:
1 Hole With Single Post
Installation
Go To Go To
Step 6 Step 6
Option 1:
3 Hole With Deckplate
Installation
6C
6A
6A
6B
6D
6E
6F
6G
6H