En g li sh – Pfister 016-2DFC User Manual
Page 3
EN
G
LI
SH
ENGLISH
7
8
10
9
12
7 TRIM FLANGE ATTACHMENT
Position Flange (7A) onto Valve (7B). Place Protective Washer (7C) on the short end
of the reversible Retainer Sleeve (7D). Screw Retainer Sleeve (7D) onto threaded
section of Valve (7B). Tighten Retainer Sleeve (7D) by hand until Flange (7A) is snug to
finished wall surface. If the short end of the Retainer Sleeve (7D) is too short, reverse
it to use the longer end.
8 HANDLE ATTACHMENT
Thread Set Screw (8C) into Handle (8D) and thread it in only three to four turns. Place
Handle (8D) onto the SValve Stem (8B) and tighten Set Screw (8C) by using the Hex
Wrench (8E) that is provided.
Make sure Set Screw (8C) is securely tightened to Handle (8D).
9 HOLE LOCATIONS FOR WALL MOUNT
Remove Front Cover (9A) from Wall Mount (9B). Use Wall Mount Screw Holes (9C) to
place the desired location. Using a punch or awl, tap the screw hole locations. Holes
must be vertically aligned.
10 ANCHOR INSTALLATION
Drill two
1
/
4
” Dia. Holes (10A). If installing into a stud, drill two
1
/
8
” Dia. holes and do not
use Anchors (10B). Insert Anchors (10B) into Holes (10A) and tap flush with wall.
11 WALL MOUNT INSTALLATION
Place Wall Mount (11A) onto wall and insert Mounting Screws (11B) through Wall Mount
Holes (11C) and tighten until Wall Mount (11A) is flush with the wall. Do Not Over
Tighten! Insert Front Cover (11D) into Wall Mount (11A).
12 DROP ELBOW & HOSE INSTALLATION
Apply PTFE plumbers tape on both ends of Pipe Niple (12A) (not included). Screw Pipe
Niple (12A) into the elbow inside the wall. The Pipe Niple (12A) is to project
1
/
4
"-
3
/
8
"
from the finished wall. Screw Drop Elbow (12B) onto Pipe Niple (12A) and tighten until
Drop Elbow (12B) is properly positioned and flush to the finished wall.
Place Rubber Seal (12C) inside Hex Hose Fitting (12D). Connect Hex Hose Fitting (12D)
into Drop Elbow Outlet (12E) by turning Hex Hose Fitting (12D).
11
3
7A
7B
9A
9B
9B
7D
8B
8C
8E
8D
7C
9C
10A
10B
3/4”
11A
11D
11B
11C
11C
11B
12A
12B
12C
12E
12D
1/4"-3/8"