Pfister VTP-E10W - Manual (Page 2)

E
N
G
L
IS
H
ENGLISH
ENGLISH
4
3
6
7
Thank you for purchasing this Price Pfi ster product. All Price Pfi ster products
are carefully engineered, and factory tested to provide long trouble-free use
under normal conditions. This product is easy to install using basic tools and
our easy to follow illustrated instructions.
3 TOOLS RECOMMENDED
• FTFE Plumber’s Tape • Spatula • Safety Goggles
• Sealant • Slotted screwdriver • Phillips Screwdriver
• Pliers • Adjustable wrench • Flashlight
• Cloth
Your installation may require other additional tools.
4 CONTENTS OF THE BOX
A Seat Cover B Outlet Connector C Wax Ring
D Toilet Bowl E Toilet Tank (for E11W only) F Toilet Lid
G Installation Kit: {Supply Valve, Flange, Hose, Rubber Gasket, [Tee Bolts (2), Nuts (2),
Washers (2)], [Brass Bolts (2), Brass Nuts (2)], [Toilet Screws (2), Plastic Washer (2),
Decorative Cap (2)], [Optional Screws (2), Optional Anchors (2), Optional Washers (2)]}
1 BEFORE PROCEEDING
WARNING: This product comes complete for installation. Read all the instructions
completely before proceeding. Price Pfi ster recommends calling a professional if you
are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes. This product is heavy and fragile; use extreme care with all parts!
2 SHUT OFF WATER SUPPLY
Locate main water supply inlets and shut off the water supply valves. These are usually
found near the water meter. If you are replacing an existing toilet, remove the old toilet
and wax ring from the fl oor and clean the fl oor surface thoroughly.
For more information about the installation or care and warranty information,
please contact your local Black & Decker HHI representative in your country
or visit www.pricepfi ster.com/international
6 WATER SUPPLY VALVE INSTALLATION
A. Remove Sleeve (6A) and Cover Nut (6B) from Supply Valve (6C).
B. Slide Flange (6D) through Water Supply Pipe (6E) until it is tight to the wall. Insert
Supply Valve (6C) into Water Supply Pipe (6E) until the end of Pipe sits fl ush inside
Supply Valve (6C).
7 INSTALL NEW WAX SEAL
Place and align Tee Bolts (7A) into Flange Groves (7B) located on the Floor Flange
(7C) of Waste Outlet Hole as shown.
5 WORK AREA INSPECTION
Verify that the Waste Outlet Hole is 12” (305 mm) (5A) from the fi nished wall (5B).
5
2
A
B
F
C
E
G
6B
6E
6C
6D
6C
6A
7A
7A
7B
7C E11W
A
B
E10W
D
5A
5B