En g l is h english, Faucet installation – Pfister GT49-YP0Y User Manual
Page 2
E
N
G
L
IS
H
ENGLISH
ENGLISH
3
4
2
FAUCET INSTALLATION
5
6
Thank you for purchasing this Price Pfi ster product. All Price Pfi ster products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfi ster
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and building codes.
NOTE: If installation surface depth is thicker than 1
1
/
2
”, order spare part
number 971-026.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3 TOOLS RECOMMENDED
• Plumber's putty
• PTFE Plumber's Tape
• Slotted screwdriver
• Adjustable wrench
• Pliers
• Flashlight
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Spout
B Handles (2x)
C Valve Bodies (2x)
D Pop-Up Assembly
E Pop-Up Rod
F Seal Rings (2x)
G Hose
H Mounting Washer
J Long Nut
K Bag [Nuts (2x), Square Washer (2x)]
L Base Ring
M Bag [Ball Rod, Strap]
If any of these items are missing, please contact Price Pfi ster Consumer Service at
1-800-Pfaucet (1-800-732-8238).
5 SPOUT ATTACHMENT
Insert Lift Rod (5A) into hole at the back of Spout (5B). Place Plastic Seal Ring (5C)
against the bottom of Spout Body (5D). With Spout (5E) facing forward, carefully
install the Lift Rod (5A), Shank (5F) and receiving Tube (5G) through the center hole
of sink (5H).
6 SPOUT INSTALLATION
From underneath sink, secure Spout Body (6A) by placing Metal Washer (6B) and
threading Long Nut (
7
/
16
Hex.) (6C) onto Mounting Post (6D). Make sure that the bumps
on Metal Washer (6B) are facing up. Tighten loosely, make sure Spout (6E) swings
equally in both directions. Firmly hand tighten Long Nut (6C). Secure Long Nut (6C)
not to exceed a
1
/
4
turn.
Caution: Do not over tighten!
2
A
5A
B
B
C
C
D
E
F
F
G
J
H
L
K
M
6A
5B
5C
5D
5E
5G
5F
5A
5H
6E
6B
6C
6D