Wright Serial #55142 and higher - Manual (Page 30)

28
WARNING
Dust Filter
Vent /
Purge
To
Tank
6.11 Transporting
Use a heavy duty trailer or truck to transport the Mid-Mount Z. Lock brake and block wheels. Securely
fasten the unit to the trailer or truck with straps, chains, cable or ropes.
o Fasten unit to trailer or truck using tie down locations shown in photos.
6.12 Loading and Unloading
Use extreme caution when loading or unloading units on/off trailers or trucks. One full width ramp that
extends beyond the rear tires is recommended rather than individual ramps for each side of the unit. The
ramp should be long enough so that the angles between the ramp and the trailer or truck does not exceed
15 degrees. A steeper angle may cause the mower deck components to get caught as the unit moves from
ramp to trailer or truck. Always put the deck in the transport (up & locked) position when loading or
unloading. Never attempt to turn the mower around on the ramp. Avoid sudden acceleration when driving
up a ramp and sudden deceleration when backing down a ramp.
6.13 Spindle and Drive Pulley Split hub R&R
•
Remove 2, ¼” bolts from split hub and install in threaded holes in hub.
•
Slowly tighten each bolt, alternating as you tighten bolts against the pulley.
•
The hub will separate from the pulley.
•
Replace grade 8 bolts and install in reverse order using the assembly holes to tighten hub onto pulley
and spindle shaft.
6.14 Fuel Evaporation System
All Wright Z’s need to have this mandatory feature.
•
Do Not alter or remove.
•
Do Not fill past the “Max Fill Level” line.
•
Over-filling could result in clogging the roll-over vent and/or contaminating the
purge canister.
•
The vapor canister is located above the engine attached to the oil cooler.
•
Inspect and clean dust filter every 500 hrs or annually.
Front tie down location
Rear tie down
locations
Assembly
hole
Threaded
Removal
holes
Assembly
hole
Tightening will
separate the hub
from the pulley