Yokogawa YFGW410 - Manual (Page 64)

<D3. Constructing a Field Wireless System>
D3-3
IM 01W02D01-01EN
n Network Interface (when set for single operation)
When [Interfaces] is selected in the menu tree of the Configurator, the following four tabs are
displayed in the main window: [Field Wireless Backbone], [Field Network 1], [Field Network 2],
and [Field Network 3].
IMPORTANT
When the setting information of these tabs is edited, all backbone devices must be restarted
when the setting information is downloaded.
l Field Wireless Backbone
When the YFGW410 is set for single operation and the [Field Wireless Backbone] tab is selected,
the tab shown in Figure D3-1 appears in the main window.
FD0301.ai
Figure D3-1 Field Wireless Backbone Setting Tab (for Single Operation)
At this tab, set the allocation method for the IP address and set the IP address and subnet mask
settings of the Field Wireless Backbone Network in the YFGW410.
With the default setting, the [Enable Automatic Backbone IP Address allocation] check box is
selected and the default settings shown below are automatically allocated.
To manually enter the [IP Address] and [Subnet Mask] settings, clear the [Enable Automatic
Backbone IP Address allocation] check box.
Item Description Default setting
IP Address IP address of Field Wireless Backbone Network 192.168.200.101
Subnet Mask Subnet mask of Field Wireless Backbone Network 255.255.255.0