Yokogawa 414 Batch Controller - Manual (Page 18)

3.2.4 Auto Restart
The Batch Controller can be programmed to continually repeat the batch
process. This mode of operation is selected during the programming procedure.
The process is started by pressing the RUN key whereby the normal batch
operation is commenced. After reaching the End of Batch (see section 3.2.3),
the Batch Controller will then wait for a pre-programmed period before
automatically resetting and starting the batch process once again.
The STOP button can be pressed at any time to interrupt the batching process
and continued using the RUN key. If, however, the process is to be aborted, the
STOP key is again pressed. The Batch Controller is reset and to restart the auto
batching process the RUN key is pressed.
16 Operation