Avital 5303 - Manual (Page 17)

14 © 2 0 0 8 D i r e c t e d E l e c t r o n i c s — A l l r i g h t s r e s e r v e d
bypassed when the system is armed. (See Table of Zones section of
this guide.) Pressing (only in Standard Configuration) again
within five seconds of arming the system will activate the Multi-
Level Security feature. Each time is pressed again, a different
security level is selected. The different security levels are selected
as follows:
➤ Press once: The siren chirps once. The system is armed.
➤ Press a second time within five seconds: The siren chirps
twice followed by a long chirp. Zone 2 is now bypassed.
➤ Press a third time within five seconds: The siren chirps
three times followed by a long chirp. Zone 4 is now bypassed.
➤ Press a fourth time within five seconds: The siren chirps four
times followed by a long chirp. Zones 2 and 4 are now bypassed.
➤ Press a fifth time within five seconds: The siren chirps
five times followed by a long chirp. All input zones, except
the ignition, are now bypassed.
Arming while driving
Your security system can be armed while driving the vehicle!
Simply press on the transmitter for two seconds while the
vehicle is running. The siren will chirp once to indicate that the
security system is armed, and then once more to indicate that the
ignition is on. The system will not respond to any input except
➜
Note: Multi-Level Security Arming only applies to a sin-
gle arming cycle. Once the system is disarmed and then
re-armed, all the zones will be active again.
G5303_2008-06H.qxd 7/9/2008 10:37 AM Page 14