Yokogawa DAQWORX - Manual (Page 32)

3 IM WX1000-01E
Setting Up GateMODBUS
7. Click the Start monitor button.
The value of each tag from the instrument is loaded, and displayed in the
loaded value column of the input tab sheet.
To quit monitor execution, proceed to step 11.
Performing a Write Test
8. Specify the Output Values of the tags on which you wish to perform the
output test in the output tab page.
9. Select the tags on which to perform the output test
10. Click the Output Test button during the Read Test.
The output values are written to registers, then the values are acquired from
the write registers and the loaded results are displayed in the loaded value
column in the output tab page.
Stopping the Read Test
11. Click the Stop monitor button.
The Monitor Test/Read Test is concluded.
Launching GateCONTROL
12. Click the Start button in the Acquisition/Status tab.
Click to display the
Error dialog box
Reconnect button
Click here to reopen
communications with the
selected instruments
The practice status
is displayed using
colors
Green: Normal
(comm. open)
Red: Error
(comm. stopped)
Yellow: Data lost, etc.
(comm. open)
No display: Stopped
Start button
Error display example