MAHLE RTI MCX-2HD - Manual (Page 17)

Page 16
Do not leave the MCX-2HD unattended while emptying the waste tank.
The pump will be destroyed if allowed to run for more than one minute after the
waste tank is empty.
Bulk Waste Container
FILL RAD IATO R & O VER FLO W
LOW ER R ADIA TOR & O VER FLO W TES T EM PTY W AST E TA NK
OFF
EM PTY WA STE TAN K
OFF EXC HAN GE C OO LAN T
EXC HAN GE C OOL ANT OR
FILL RA DIA TOR & O VER FLO W
OFF
Black Hose
SYS TEM VA CUU M
SYS TEM PRE SSU RE
& O VER FLO W
LOW ER R ADIA TOR
Green Hose
FILL RA DIA TOR & O VER FLO W
EXC HAN GE C OO LAN T O R
EM PTY WA STE TAN K
& O VER FLO W
LOW ER R
ADIA TOR
EM PTY WA STE TAN
K
TES T
EXC HAN GE C
OO LAN T & O VER FLO W
FILL RA DIA TOR
OFF
OFF
SYS TEM PR ESS URE
SYS TEM VA CUU M
OFF
LOW
ER R ADIA
TOR
& O VER FLO W
EMPTYING THE WASTE TANK
The Waste Tank can be emptied two different ways.
A. The Waste Tank can be removed from the MCX-2HD and transported to the
area where it is to be emptied. A quick connect coupler is installed on the black
hose to make this disconnection quick and clean.
B. The MCX-2HD can be used to pump the waste coolant directly from the Waste
Tank into another waste collection tank. A 12 volt battery will be required to
power the MCX-2HD.
1. Install the Wand on the black hose.
2. Turn the control valve to EMPTY WASTE TANK.
3. Press the top of the EMPTY WASTE TANK selector switch to start the pump.
4. Hold the Wand over the Bulk Waste Container and open the valve.
5. Waste coolant will be pumped directly from the MCX-2HD Waste Tank into the
Bulk Waste Container.
6. Close the valve on the Wand when done.
7. Press the bottom of the EMPTY WASTE TANK selector switch to stop the
pump.