MAHLE RTI BFX-2 - Manual (Page 7)

Page 6
N E W T A N K = # # O Z
S E L E C T P R O C E S S
E N T E R S E Q U E N C E
X X - X X - X X - X X
O P E N B L E E D E R S
P R E S S > C O N T I N U E <
R E M A I N I N G = # # O Z
B L E E D I N G X X
P R E S S > C O N T I N U E <
C L O S E B L E E D E R S
³ This will display.
Select correct Master Cylinder Adapter and
install on the Master Cylinder.
Connect Fill Hose to Master Cylinder Adapter.
Press Fill Master Cylinder and check that
adapter is sealed and there are no leaks.
Press Fill Master Cylinder to stop the process.
Raise vehicle to comfortable level to access
the brake bleeder valves. Use caution to not
disconnect power cable from battery or put
strain on the Fill Hose connected to the Master
Cylinder.
Connect a Bleeder Hose to each brake bleeder
valve. Match colors on Bleeder Hoses to the
control panel graphic.
Press FLUSH.
³ This will display.
Press LF, RF, LR and RR in sequence desired
during the sequential brake fluid exchange.
The order pressed should be according to the
recommended sequence as specified by the
manufacturer for the particular vehicle.
The order entered will be displayed.
Press CONTINUE.
³ This will display.
Open all bleeder valves.
Press CONTINUE.
³ This will display.
This display will show each bleeder as fluid is
exchanged.
³ This will display.
Buzzer will beep every 20 seconds to indicate
procedure is complete.
Press CONTINUE and then close bleeders.