MAHLE RTI BFX-1 - Manual (Page 9)

IMPORTANT: Test drive vehicle after service to verify proper
brake system performance.
Page 8
23. Test the brake system for proper pedal pressure. Press pedal to
floor, hold for 5 seconds, release and inspect bleeders for leaks.
Tighten bleeder if needed and retest. Take vehicle on test drive.
Exchange continued
17. When the fluid in all 4 Bleeder Hoses has been adequately exchanged turn all four
VACUUM BLEEDER switches on, close the bleeder valves and turn off the EXCHANGE
BRAKE FLUID and VACUUM BLEEDER switches.
18. Remove Bleeder Hoses from bleeders, return to unit and lower vehicle.
19. Remove Master Cylinder Adapter from the master cylinder
20. Disconnect Fill Hose from the Master Cylinder Adapter.
21. Adjust level in the master cylinder by using the Vacuum Hose and the EMPTY MASTER
CYLINDER switch to lower or the FILL MASTER CYLINDER switch and the Fill Gun on
the New Fluid Hose to raise.
22. Remove battery connections and install the master cylinder cover.