UView Spotgun Jr./PICO-Lite Kit - Manual (Page 2)

4
SPOTGUN™ JR. INJECTION SYSTEM LEAK DETECTION LIGHT INSTRUCTIONS
3
PULL
PUSH
2
1
12V/50W Light
1. Attach the lamp to the appropriate power supply.
2. Wear the prote ctive UV enhancing glasses.
These glasses will allow you to locate the
leak easier by cutting out the visible light.
The UV lamp is now ready for operation.
To operate, depress the momentary switch
(located on handle).
The lamp will stay on as long as the switch
is depressed.
The lamp will illuminate immediately. It shuts
off once you release the switch.
Lamp Instructions
Lamp Instructions
Micro-Lite™ for #333000
IMPORTANT INFORMATION!
Continuous operation of UV lamp can produce high temperatures. To prevent this condition
and extend bulb life, this model has been designed to produce instant UV light. This feature
eliminates the need for continuous operation of lamp. A series of short inspection intervals
lasting 2 to 3 minutes in duration is recommended.
• DO NOT EXCEED RECOMMENDED DUTY CYCLE OF 3 MINUTES ON / 2 MINUTES OFF
• NEVER OPERATE LAMP WITHOUT UV SAFETY GLASSES
• DO NOT PLACE LAMP ON OR NEAR FLAMMABLE OR COMBUSTIBLE LIQUID/GASSES
• NEVER TOUCH UV LENS FILTER DURING USE- allow to cool before handling
• DO NOT LOOK DIRECTLY INTO UV LIGHT BEAM
CAUTION!
Momentary
Switch
Battery
Clips
Cordless Leak Detection Lights for 332010 & 332220A
1. Continuous use: Twist the end cap clockwise until the lamp turns on. Turn the end
cap in the opposite direction to turn the lamp off.
2. Short-term use: Press and hold the end cap button for instant on.
Battery Replacement
Twist the end cap counterclockwise to open. Replace 3-AA batteries positive end
toward lamp head. Replace end cap.
SET-UP INJECTION GUN SYSTEM
1. Hold the disposable cartridge in an upright
position then remove cap and seal from cartridge.
2. Attach hose (R-134a) to the top of the disposable
cartridge then remove drip cap from adapter.
(Fig. 1)
3. Push the release lever on the injection gun with your
thumb, and pull the rod all the way back.
(Fig. 2)
4. Install cartridge into gun assembly. (Fig. 3)
5. Squeeze trigger until piston seats in disposable cartridge.
Now the Injection gun system is ready to be used.
OPERATION (R-134a)
The Injection gun injects the dye into the A/C system
without the need to evacuate any refrigerant. To use,
proceed with the following steps:
1. Connect injection gun system to the low side port
of the A/C system.
2. Inject dye into the A/C system by squeezing the
trigger
(Fig. 4). See "Dye Dose Chart" below.
3. Disconnect injection gun system from the A/C port.
4. Attach drip cap to the adapter.
5. Install “Dye Service Sticker” in a visible location under
the hood.
6. Start the engine and turn on the A/C to maximum for
a few minutes. This is to circulate the fluorescent dye
in the system.
7. Turn the engine "OFF". Check for leaks using an
ultraviolet lamp. Possible leak areas will glow a
bright yellow/green when exposed to UV light.
Note: Smaller leaks may require longer circulation time.
Let the A/C system run for a few days then reinspect.
R-12 SET-UP
1. Complete all steps in SET-UP procedure.
2. Remove R-12 adapter drip cap and attach to low
side port of the A/C system.
3. Attach injection gun system to the R-12 adapter valve.
4. Repeat steps from 2-7 in OPERATION procedure
above. (As applicable).