PreSonus StudioLive 328AI - Manual (Page 12)

8
2 Getting Started
2.2 Level Setting Procedure (18sAI)
StudioLive ™ AI-Series Loudspeaker
Owner’s Manual
10. Both the Microphone and Line inputs should be set so that the green Signal
LED is illuminated most of the time, but the red Clip LED illuminates only
with the highest transient peaks or not at all.
11. If more output level is required, turn the Speaker level knob clockwise. This
is the master level control for your loudspeaker. It controls the mixed signal
of the Mic and Line inputs.
12. If you are using the input mixer of one loudspeaker to connect
a microphone and a line-level source, or if you are running
a mono system, connect the Mix Out from the loudspeaker
to which your sources are connected to the line input of
the second loudspeaker and repeat steps 9-11.
2.2 Level Setting Procedure (18sAI)
1. With the power switch in the Off position, connect the locking IEC plug to
the IEC socket connection on the back of each loudspeaker and plug it into
a grounded AC outlet or surge protector.
2. Turn the Mic, Line, and Speaker level knobs on your full-range loudspeakers
fully counterclockwise to the lowest position.