Stewart Audio AV25-2 NET+ - Manual (Page 7)

2.5 Output Connections
Stewart Audio recommends using high-quality, heavy-gauge speaker
wire and connectors to send the output signal of your amplifier to the
speakers. Use the following table as a guideline when selecting your
wire gauge.
Speaker leads connect by means of terminal block connectors supplied
with the unit. Strip speaker leads 1/4” and insert into connector ob-
serving proper polarity. With a small, flat-blade screwdriver, tighten the
screw until the leads are held securely in place. Inspect for possible
shorts or broken wires.
Distance Wire Gauge
Up to 25 ft. 16 AWG
26-40 ft. 14 AWG
41-60 ft. 12 AWG
+ -
+ - + -
+ -
Terminal Block Connector
(Rear of AV25-2 NET)
Channel 2 Channel 1
3 Operation
3.1 Operating Precautions
1. Before use, your amplifier must be configure for proper operation,
including input and output wiring hookup. Improper wiring can re-
sult in damage to equipment or potentially harm to the operator.
Consult section 2 for setup instructions.
2. Tampering with the circuitry, or making unauthorized changes is
not only dangerous but may also violate local regulations.
3. Use care when making connections between the amplifier and the
input or output equipment. Using equipment that is not capable of
handling the output wattage may lead to permanent damage.
NOTE: Stewart Audio will not be held responsible for
damage to your AV25-2 NET+ or connected equipment if
the instructions in this manual are not followed.