ReadyLIFT Toyota Tacoma 5-Lug SST Lift Kit, 2005-2014, 2WD - 2.75F/1.75"R" - Manual

ReadyLift® (Part# 69-5510) Installation Instructions
2005-2008 Toyota Tacoma 2WD 5 Lug (Install Video Online at ReadyLift.com)
ReadyLift Suspension Inc.
3201 W MacArthur Blvd, Santa Ana, CA, 92704
T o l l F r e e ( 8 8 8 ) 9 2 2 -2 2 9 4 L o c a l ( 7 1 4 ) 8 6 2 - 2 9 6 8 F a x ( 7 1 4 ) 8 6 2 - 2 9 7 2
9 / 1 8 / 2 0 0 8
3.
2.
1.
Position truck on a flat surface and lift vehicle by the frame so that the
front wheels are off the ground. Support the vehicle by the frame using
jack stands or a (2) two post lift if available.
Remove front driver side wheel. Remove
10mm ABS line retention bracket bolt from the
upper control arm.
(Insert 1)
Remove 10mm bolt on spindle.
(Insert 2)
Disconnect ABS line connector and position
line out of the way.
(Insert3)
Remove the 12mm brake line retaining bolt
from the bracket connected to the strut..
(Insert 4)
Insert 1 Insert 2
Insert 4 Insert 3
Remove the upper 12mm sway bar end link nut
and 17mm lower end link nut . Remove the
end link.
(Insert 5 & 6)
Remove lower strut mount nut and bolt.
(Insert 7)
Remove the two upper control arm mounting
bolts.
(Insert 8)
This will allow enough room to remove the
strut.
Insert 8 Insert 7
Insert 6
Insert 5
Insert 9
Loosen,
DO NOT REMOVE , the lower control
arm nuts. Be sure to mark the alignment
cams and the flanges they contact.
(Insert 9)
Remove the three upper strut mounting nuts.
Remove the strut from the vehicle.
Please read instructions thoroughly and completely before beginning installation.
Check www.readylift.com for any updated installation instructions.
Installation by a trained mechanic is recommended.