ReadyLIFT Dodge Ram Mega Cab, 2006-2013, 2WD & 4WD, Non Camper Package - 2 Rear Block Kit" - Manual (Page 3)

No Photo
Next, lower vehicle to the ground and torque
the u-bolts with the weight on the axle. Re-
check all work and tighten all hardware to
factory spec., then test drive.
www.ReadyLIFT.com
Phone (702)410-2300
Installation Instructions (66-1201 & 66-1202)
Raise rear of vehicle on level ground and support frame. Support axle and disconnect lower shock mounting hardware.
Disconnect U-bolts and remove, one side of vehicle at a time. Slowly lower rear axle.
Place new lift block on axle pad, center pin down. Carefully raise axle and align centering pin.
Install new u-bolts and hardware, reattach shock and tighten.