ReadyLIFT Ford F350 Super Duty Radius Arm Bracket Kit User Manual
Page 4
Advertising
Reinstall the factory coil springs with rubber isola-
tors, making sure the springs are clocked properly
on the spring perch. Raise axle enough to recon-
nect the lower shock mounts and sway bar end
links. Tighten all hardware to factory spec and
reinstall wheels/tires. Torque wheels and test
drive.
www.ReadyLIFT.com
Phone (702)410-2300
Installation Instructions (67-2550 & 67-2551)
Remove bolt from middle of spring perch
Place billet spacer on axle under spring perch
Secure with new provided hardware and torque to spec.
Disconnect vacuum line and clip from brake bracket
Bend tab 180 degrees so line will relocate behind bracket
Then reconnect vacuum line and clip and reattach bracket
Advertising
This manual is related to the following products: