STI 6255 - Manual

INSTALLATION OF STI-6255 MINI THEFT STOPPER ®
All specifications and information shown were current as of publication and are subject to change without notice.
6255 JAN2013
Safety Technology International, Inc.
2306 Airport Road • Waterford, Michigan 48327-1209
Phone: 248-673-9898 • Fax: 248-673-1246
Toll Free: 800-888-4784 • E-mail: [email protected]
Web: www.sti-usa.com
Safety Technology International (Europe) Ltd.
Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch
Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999
Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only)
E-mail: [email protected] • Web: www.sti-europe.com
CLIP ACTIVATION
EXTINGUISHER PIN
BREAKAWAY TIE WRAP
TO ALARM
MAGNET
REED SWITCH
CABINET
DOOR
REED SWITCH JACK
MINI
THEFT
STOP
PER
CABINET
REED SWITCH
MAGNET
CABINET DOOR
STI RECOMMENDS
THE USE OF PLASTIC
SPACERS WHEN MAGNET
IS MOUNTED ON STEEL
SURFACES AS SHOWN
DOUBLE SIDED FOAM TAPE
ADDITIONAL TAPE MAY BE
REQUIRED
DOUBLE SIDED
FOAM TAPE
NOT INCLUDED CABINET
CABINET
DOOR
MAGNET
PLASTIC SPACER
19039 #6 x 1 1/4 in.
(4) PROVIDED
REED SWITCH
ROUTE BREAKABLE SEAL
THRU PULL PIN RING
AND AROUND SQUEEZE
HANDLE AS SHOWN
REPLACEMENTS SUB-65
(SET OF 5)
ACTIVATION CLIP SUB-131
TO MINI THEFT STOPPER HOUSING
PULL PIN RING
INSERT PULL PIN
THRU HOLES IN
ACTIVATION CLIP
INSTALLATION NOTES:
1. Magnet and reed switch must be within 1/2 in. on
non-metallic surface when door is closed. Metal
surface requires closer spacing and use of plastic
spacers.
2. When mounting alarm inside cabinet, deactivation
pin can be removed without sounding alarm. When
door is closed, alarm is active upon next opening of
door, be sure to test this installation by re-opening
door. If alarm does not sound, check magnet/reed
switch installation. If alarm sounds reset alarm with
deactivation pin, then remove pin and close door.
Alarm is now ready to sound when door is opened.
3. Alarm will reset in approximately 3 minutes after
cabinet door is closed or activation clip is reset.
4. To reset the alarm immediately or service the fire
extinguisher, the deactivation key pin must be used.
HOUSING INSTALLATION CABINET MOUNT
FREE STANDING EXTINGUISHER
MAGNET AND REED SWITCH SECURED
WITH (4) SCREWS
MAGNET AND REED SWITCH SECURED
WITH ADHESIVE PATCH
CABINET MOUNT OPTIONS FOR SUB-132
Electronic warranty form at www.sti-usa.com/wc14