STI 34409 - Manual

— 1 —
Installation and Operation Manual
STI 4-Channel Receiver
Thank you for purchasing the STI 4-Channel Receiver. Your satisfaction is very important to us.
How the Product Works
STI offers multiple wireless products designed to alert you of several different conditions. The
4-Channel Receiver allows you to monitor up to 4 different STI sensors at a single convenient
location. The STI wireless alert series uses a system to ensure other non STI sensors are not
enrolled. The STI 4-Channel Receiver allows you to latch any alert until reset.
Before You Start
Make sure to read all instructions per task prior to beginning. Refer to this drawing to become
familiar with all parts.
Model: STI-34104
STI-30104
LAMP CONTROLLER
(OPTIONAL)
AC ADAPTER
GREEN
LED
TRANSISTOR
OUTPUT JACK
RECEIVER ANTENNA
SPEAKER
STI-34104
INDOOR RECEIVER
BUTTON
RED LED
SENSOR TRANSMITTER CAP
SENSOR TRANSMITTER BASE
MOUNTING
TUBE CAP
WALL MOUNT (INCLUDED)
NOT NEEDED FOR POLE
MOUNT INSTALLATION
2 “C” BATTERIES
(NOT INCLUDED)
SENSOR TRANSMITTER
12”MOUNTING TUBE
MOUNTING STAKE
SENSOR TRANSMITTER
BOTTOM
SENSOR TRANSMITTER
MOUNTING
TUBE CAP
MOUNTING STAKE
SENSOR TRANSMITTER BOTTOM
SCREWS
RECHARGEABLE NiMH BATTERIES
H L
SENSITIVITY JUMPERS
(SOLAR TYPE)
SENSITIVITY JUMPERS
(BATTERY TYPE)
H L
FINGER
NOTCHES
REMOVE PLASTIC TAB
FROM BATTERIES
DRIVEWAY
3’OR
LESS
25' OR MORE
PLACE SENSOR
TRANSMITTER 3' OR
LESS FROM EDGE OF
DRIVEWAY AND 25'
OR MORE FROM STREET.
12’
MAX
DRIVEWAY
PLACE SENSOR
TRANSMITTER 3' OR
LESS FROM EDGE OF
DRIVEWAY AND 25+
FEET OR MORE FROM
STREET.
25' OR MORE
3' OR
LESS
12'
MAX
+
+
-
B
DETAIL B
SCALE 2:1
B
C
H L
-
+
+
-
B
-
FINGER NOTCHES
DO NOT
PULL ANTENNA!
WALL MOUNT (INCLUDED)
NOT NEEDED FOR POLE
MOUNT INSTALLATION
SENSITIVITY
ADJUSTMENT
SENSITIVITY
ADJUSTMENT
POWER CONNECTOR ANTENNA CONNECTOR
12”MOUNTING TUBE
GREEN
LED
TRANSISTOR
OUTPUT JACK
RECEIVER ANTENNA
SPEAKER
BUTTON
RED LED
POWER CONNECTOR ANTENNA CONNECTOR
4-Channel Receiver STI-34104
Receives up to 4 different STI Wireless Alert Series Sensors
Program a Sensor
1. Plug antenna into the antenna (red) connector on the receiver.
2. Plug adapter into the wall.
3. While holding down the receiver button, plug the adapter into the 4-Channel
Receiver. A series of beeps/tones will begin playing. Release button when beeps/tones
finish. The red and green LED’s will flash quickly. The receiver is now in program mode and
you have 1 minute to program all sensors.
4. Activate a sensor to program into 4-Channel (refer to your sensor instructions). A tone or
series of beeps will sound representing the channel the sensor programmed into (i.e.: one
beep is zone 1, two beeps is zone 2, etc.).
5. If more sensors are to be programmed, repeat step 4.
6. After programming sensor(s), wait a minimum of 5 seconds, press receiver button to exit
Program Mode or receiver will exit program mode automatically within one minute.