STI 9707 - Manual

Safety Technology International, Inc.
2306 Airport Road • Waterford, Michigan 48327-1209
Phone: 248-673-9898 • Fax: 248-673-1246
Toll Free: 800-888-4784 • E-mail: [email protected]
Web: www.sti-usa.com
Safety Technology International (Europe) Ltd.
Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch
Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999
Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only)
E-mail: [email protected] • Web: www.sti-europe.com
IMPORTANT:
Do not attempt to install reflective beam guard until both
the transmitter and reflective mirror have been perfectly
aligned and tested according to the System Sensor
installation directions furnished with detector unit.
INSTALLATION INSTRUCTIONS
1. Center the wire guard over existing reflective beam
housing making sure center cutout in wire guard is
positioned over beam lens window.
2. Mark and drill (4) holes as shown in pictorial. The
Beam Smoke Guard may be spray painted once prior
to installation.
SERVICE
1. Periodic cleaning of Beam Smoke Guard is required
to prevent buildup of dust and other matter.
2. To service the System Sensor unit, back off the (4)
screws, rotate clamps and carefully remove wire
guard. When reinstalling wire guard, care must be
taken not to hit or bump the reflective beam housing
or misalignment may occur.
INSTALLATION OF STI-9706/STI-9707 BEAM SMOKE GUARD
All specifications and information shown were current as of publication, and are subject to change without notice.
9706/07IS APRIL 2009
EXISTING FLUSH MOUNT
SYSTEM SENSOR BEAM UNIT
ANCHOR
(4) PROVIDED
19020 CLAMP (4) PROVIDED
MAY BE INSTALLED ON SIDE (AS
SHOWN) OR TOP AND BOTTOM
DRILL (4) .25 in.
(6.3mm) HOLES
SCREW #10 X 1 1/2 in.
(4) PROVIDED
9
STI-9706 STI-9707
ELECTRICAL CONDUIT
(ONE OF TWELVE POSSIBLE LOCATIONS)
THE STI-9707 PROTECTIVE WIRE GUARD
WILL FIT ANY EXISTING LOCATION
DRILL (4) .25 in.
(6.3mm) HOLES
SCREW #10 X 1 1/2 in.
(4) PROVIDED
ANCHOR
(4) PROVIDED
EXISTING SURFACE MOUNT
SYSTEM SENSOR BEAM UNIT
19020 CLAMP (4) PROVIDED
MAY BE INSTALLED ON SIDE
(AS SHOWN) OR TOP AND BOTTOM
6
STI-9707
PRODUCT DIMENSIONS
E
9.62 in. (244mm)
CENTER
CUTOUT
FRONT VIEW
5.50 in.(140mm)
10.32 in.
(262mm)
11 in.
(280mm)
4 in.
(102mm)
SIDE VIEW
9
4.00 in.
(102mm)
2 in.
(51mm)
10.82 in.
(275mm)
1
6.23 in.
(158mm)
4.54 in.
(115mm)
2.14 in.
(53mm)
3.51 in.
(89mm)
CENTER DIMENSIONS
Electronic warranty form at www.sti-usa.com/wc14