STI 9845 - Manual

INSTALLATION OF STI-9845 SMOKE DETECTOR DAMAGE STOPPER ®
All specifications and information shown were current as of publication and are subject to change without notice.
9845 DEC2012
Safety Technology International, Inc.
2306 Airport Road • Waterford, Michigan 48327-1209
Phone: 248-673-9898 • Fax: 248-673-1246
Toll Free: 800-888-4784 • E-mail: [email protected]
Web: www.sti-usa.com
Safety Technology International (Europe) Ltd.
Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch
Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999
Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only)
E-mail: [email protected] • Web: www.sti-europe.com
INSTALLATION INSTRUCTIONS:
1. Center wire guard over device as shown.
2. Place hinge clamp in upper right position.
3. Mark and drill ¼” diameter hole
4. Mount wire guard over device using right hinge clamp and tighten screw.
This should hold wire guard in place. Mark and drill the remaining 3
clamp holes (if necessary, loosen upper right clamp screw and remove
wire guard).
5. Mount wire guard, all 4 clamps and screws. Tighten firmly.
1) Center Wire Guard Over Device As Shown.
2) Place Wire Guard Clamp In Upper Right Position And Mark Hole Location.
3) Drill Hole Diameter As Shown.
4) Mount Wire Guard Over Device Using Upper Right Clamp And Tighten Screw.
This Should Hold Wire Guard In Place While Marking The Remaining 3 Clamp Holes.
5) Loosen Upper Right Clamp Screw And Remove Wire Guard (If Necessary) And
Drill The Remaining 3 Holes.
6) Mount Wire Guard, All 4 Clamps, Screws, And Tighten Firmly.
RECOMMENDED CLAMP PLACEMENT AS SHOWN
19013 #10 x 1 1/2 in.
SCREW (4) PROVIDED
USING DRILL 1/4 in. (6.3mm) DIAMETER HOLES
ANCHOR (4) PROVIDED
AREA OPEN FOR
CONDUIT ACCESS
19020 HINGE CLAMP
(4) PROVIDED
4.07 in.
(104mm)
9.2 in.
(234mm)
6.7 in.
(167mm)
XTRALIS OSID DETECTOR
Electronic warranty form at www.sti-usa.com/wc14