STI 9716 - Manual

Safety Technology International, Inc.
2306 Airport Road • Waterford, Michigan 48327-1209
Phone: 248-673-9898 • Fax: 248-673-1246
Toll Free: 800-888-4784 • E-mail: [email protected]
Web: www.sti-usa.com
Safety Technology International (Europe) Ltd.
Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch
Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999
Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only)
E-mail: [email protected] • Web: www.sti-europe.com
INSTALLATION OF STI-9716 CAMERA DAMAGE STOPPER ®
All specifications and information shown were current as of publication and are subject to change without notice.
9716IS MARCH2008
17 in.
(431mm) 25 in.(635mm)
17 in.
(431mm)
1/2 in.(12.7mm) DIA. HOLES
1 1/2 in.(38mm) DEEP
1/4 x 1 1/2 in.
LAG SHIELD
1/4 x 1 3/4 in. HEX LAG SCREWS
(8) PROVIDED
PRODUCT DIMENSIONS
IMPORTANT:
Do not attempt to install guard until the appliance has been properly aimed and tested.
Lag shields are for use in concrete and the mortar joints of block or brick walls. For wood
installations drill pilot holes 13/64” diameter for lag screws only. Lag shields are not
required for this type of installation. Do not install guard on hollow backed drywall.
INSTALLATION INSTRUCTIONS
1. After alignment and test has been completed, use the guard as a template.
2. Center the guard over existing appliance. Slots must have openings facing
downward as shown.
3. Mark (8) mounting holes. Drill 1/2 in. diameter holes 1 1/2 in. deep.
4. Insert lag shields into holes flush or slightly below surface.
5. Install lag screws until approximately 3/4 in. remain outside of wall.
6. Place guard onto screws and tighten.
IMPORTANT:
To service camera, loosen the (8) lag screws and slide guard upward, use caution not
to hit or bump appliance.
NOTE:
If after installation interference of one wire strut is noticed in appliance operation, the
interfering strut may be cut without structural weakening or loss of warranty.
Electronic warranty form at www.sti-usa.com/wc14