STI 34109 - Manual (Page 2)

— 2 —
ON BLINKING
GREEN LED AC/DC power on Signal Received
RED LED Low Battery Alert Signal Transmitted
(only with AC/DC power on)
SPECIFICATIONS
• External Supply: 9-18V AC or DC, 15 mA nominal (recommended 30+ mA rating).
• Three (3) 1.5V AAA Alkaline batteries: external power backup (up to 72 hours).
• Housing Dimensions: 4 x 6 3/8 x 1 ¼ in.
• Antenna length when inserted in housing: 7 ¾ in.
OPERATION
The REPEATER receives distant STI protocol sensor signals and repeats the information to the receiver.
Generally, STI sensors send 8 identical signal “packets” of information. The REPEATER rejects any signal that is
not an STI protocol packet and retransmits the complete 8 packet set to the receiver.
STI REPEATER’S wireless signals
• Tamper Signal – tamper switch released when cover is opened or damaged
• Tamper Restore Signal – tamper condition corrected
• Low Battery Signal – battery charge low
• Low Battery Restore Signal – low battery condition corrected
• Supervisory Signal – sent every hour to monitor that REPEATER is within range
REPEATER and sensor enrolling
• The receiver can monitor the REPEATER’S supervision and trouble signals when they are enrolled (if desired).
• To manually send a REPEATER signal, press and release the tamper switch. Ensure the red LED blinks.
• To enroll sensors, follow the receiver’s programming instructions.
LEDS
FEATURES
• Extends system range.
• Receives and retransmits distant STI protocol wireless device signals (except for STI 8-Channel Receivers
signals) to receivers.
• Sensor reprogramming not required.
• All STI protocol alarm, supervisory and trouble signals are repeated to receivers.
• REPEATERS have their own unique ID for supervisory, tamper alert and low battery signals that can be
monitored with receivers.
• Antennas increase range for both reception and transmission of signals.
• Backup battery protects during loss of external power (up to 72 hours).