STI WS110TX - Manual (Page 3)

2.3.Connect the dialer STI-WS110 to your home telephone:
A phone line must be connected to the dialer in order for the dialer to work.
a.Open the battery door at the back; there are 2 sockets for telephone cables.
b.Connect the “Line” socket to your wall telephone jack.
c.Connect the “Phone” socket to your telephone, which then will share the same phone line with the Dialer plus. Normal telephone
functions are interrupted only during emergency, when Dialer plus takes control of the phone line.
2.4 Trouble Shooting
- If the LCD screen shows “FAIL” this means the telephone line is not properly attached or phone connection is invalid.
Please check the connection
- If the recording quality is low: Please record again in a quiet environment
with your mouth very close to the microphone (2-6 inches).
Section 3 - INSTRUCTION FOR THE RECIPIENT
There are several things your call recipients should know in order to successfully receive and terminate an emergency call from
your dialer. Make sure your dialer recipients understand what to do when they receive your emergency call. Therefore, it is a good idea
to give them a copy of this page for their reference.
3.1 To START speakerphone conversation
After having listened to the recorded message, press the pound key (#), to confirm that the message is NOT merely delivered to a
voice mail. Activate the “Listening” function by pressing “1” and “Speaking” function by pressing “3”. These can only be used when the
call recipient has pressed the pound key (#). Time out period is 60 seconds and recipient can extend either the listening time or speaking
time by pressing “1” or “3” accordingly. With each pressing, a further 60 seconds will be allowed by the Wireless Auto Dialer.
3.2 To EXTEND the time out for speakerphone conversation
Time out period is 60 seconds; the recipient can extend the time out for another 60 seconds by pressing (1) to listen-in and (3) to
speak-in. The conversation will be disconnected if the dialer receives no instruction.
3.3 To STOP the emergency message of the existing call AND all the remaining calls.
When the message is finished, press (#). This will stop the dialer from calling existing number and all the remaining phone numbers.
This termination will result in disconnecting the existing call and stop calling all the remaining phone numbers.
3.4 To DISCONNECT all calls after conversation
Once the speakerphone conversation is over, the recipient should disconnect the call by pressing (#) instead of just hanging up the
phone. This will terminate the connection for all existing calls and the remaining calls.
Section 4 – HOUSE CODE SETTINGS
You can change the house security code on each sensor, smart panel and other modules of your security system to avoid interference
with other systems.
In most cases you will NOT need to change the factory settings of the house security code.
If the Smart Panel and sensors activate intermittently or do not work at all, you may be able to solve the problem by changing the house
security codes on all system modules.
There are 4 jumpers/dip-switches on each device.
Remove the jumper compartment cover, then pull out
the jumper to change the house security code
setting. Make sure the jumpers on the Smart
Panel and sensors match exactly.
Dip-Switches
for house
security code - Key Fob Remote
Default house code: 1: ON, 2: ON,
3: ON, 4: ON
Jumpers for
house security
code
- Smart Panel
- Each sensor
Default house code:
1: ON, 2: ON, 3: ON, 4: ON
*Jumper: ON = Plugged, OFF = Pull Out