STI WS105 - Manual

Wireless Garage Door Sensor STI-WS105
1. Introduction
The Garage Sensor consists of two pieces.
The sensor detects when garage door is
opened. The two parts are fastened on garage
door and its frame. One part functions as a
transmitter and t he other as a magnet. Once
the sensor is installed, any abnormality in the
circuit will trigger an alert message that is
transmitted to the smart panel.
It is typically designed for the roller shuttle
garage door; it can also be used in other types
of garage doors (e.g. sectional garage door if it
can fit the installation requirements).
2. Installation
First, determine the location of the sensors.
*NOTE:
- Make sure the garage door sensor is installed indoor.
- The Sensors should be mounted at the lower part of the garage door and its frame.
- There are some installation criterion, please see the below two pictures for reference.
- The Sensors should not be placed near extreme
temperature sources (ovens, stoves, etc.)
A. Installing the Garage Sensor
- Mount the transmitter on a fixed flat surface of
the garage frame.
- Mount the magnet on garage door
- The transmitter side marked w ith a > /< must
match the same position on both sides of the
diagram.
- The transmitter and the magnet must be no more
than 3/8” apart.
1
B. Mouning with the double sided adhesive
- Ensure that the mounting surface is clean.
- eel back one l ayer o f the protective film and
attach it to the transmitter.
- eel back the remaining layer of the protective
film and press the transmitter firmly in place
against the mounting surface until firmly attached.
- Repeat to attach the magnet.
Installation and operating instructions
less than 3/8”
less than 3/8”
P
P