STI 30104 - Manual (Page 2)

2306 Airport Road
Waterford, MI 48327
Phone: 248-673-9898 · Toll Free: 800-888-4784
Fax: 248-673-1246
www.
sti-usa
.com
Operation
1) Set the Lamp Controller mode: ON (manually turns the lamp ON), Timer
(activated by the receiver), or OFF (manually turns the lamp OFF).
2) Set the time for the lamp to be turned ON each time the receiver is activated,
2 minutes, 5 minutes, 10 minutes, or
∞ (turns on indefinitely until manually
reset). To manually reset the Lamp Controller turn the timer switch to OFF
then back to TIMER.
3) The Red LED light turns on whenever the Lamp Controller is powering the
lamp.
NOTE:
The Lamp Controller is triggered by a 3.5-12V DC, 1 second pulse. The
jack is a 1/8 inch mono audio plug (negative tip).
WARNINGS
FOR INDOOR USE ONLY. For use with 250 Watt or less incandescent lamps.
CANNOT be used with 3-prong grounded plugs. When using with a lamp, keep
lamp away from bed coverings, curtains or other materials which may present a
fire hazard. Do not connect to heaters or other heat-producing appliances.
Keep away from water and damp areas. To prevent electric shock, match wide
blade of plug to wide slot and fully insert end.
One Year Limited Warranty
ETL Listed
Maximum Load: 250 watts incandescent lamp
Made in China
LIMITED WARRANTY
Safety Technology International, Inc. warrants to the original consumer/purchaser that this product
shall be free of defects in material and workmanship under normal use and circumstances for a period
of one (1) year from the date of original purchase for use.
Electronic warranty form at www.sti-usa.com/wc14.
LAMP CONTROLLER 03/12