Anthro POC Cart Assembly Instructions - Manual

TECHNOLOGY FURNITURE ®
01– Star Base...........................................Qty..1................... 250-5027-03
02– Trunk & Column
. (light.load).........................................Qty..1................... 835-5017-00
. (heavy.load)......................................Qty.1................... 835-5289-00.
03– Handle Side-Y................................Qty..1................... 225-5736-00
04– Release Lever.................................Qty..1................... 835-5391-00
05– Top Shelf...........................................Qty..1................... 100-6494-00
06– Top Plate..........................................Qty..1................... 225-5734-23
07– Flat Head Cap Screw...................Qty..4................... 325-5215-00
08– Handle Side-X................................Qty..1................... 225-5735-00
Step 1
Insert the Casters into the Star Base. Place the Star Base
on the floor and lock the two Locking Casters to keep it
from rolling around.
Orient the Trunk with the Base as shown at right. Then,
push the Trunk into the Base.
NOTE:.Make.certain.to.fully.insert.the.Trunk.into.the.Base.by.
applying.enough.pressure.to.the.top.of.the.Trunk..
09– Handle Cap Screws......................Qty..2................... 325-5034-00
10– 3 /
4
” Wood Screws.........................Qty..6................... 325-5106-00
11– 13” Handle Tube............................Qty..1................... 125-5235-00
12– Nylon Lock Nut............................Qty..4................... 325-5189-00.
13– 4” Locking Caster ..................... Qty..2................... 150-5011-03.
14–.4” Non-locking Caster...............Qty..3................... 150-5010-03
Rev. F February 2010 Questions? 1-800-325-3841 SAVE THESE INSTRUCTIONS!
03
01
05 06
07
02
08
09
10
11
Component list for POCCzz/xx and POCHzz/xx.
Hello! Thank you for choosing Anthro.
Before beginning assembly of your POC Cart, please take a
moment to review the parts list below to verify that your
shipment is complete. Also, review the assembly instructions
of all the Anthro products included in this installation.
The following Tools have been provided for this assembly.
Hex Driver 5 /
32
”.............................Qty..1................... 375-5000-00
Hex Key 3 /
16
”..................................Qty..1................... 375-5028-00
An.Adjustable.Wrench.(not.provided).is.also.required.
SAVE THESE INSTRUCTIONS!
POC Cart
Assembly Instructions
12
Panel
Knobs
Locking
Casters
fRONT Of CART
Panel
Knobs
Locking
Casters
REAR Of CART
Base
Top of
Trunk
Step 2
Lay the Top Shelf with predrilled holes facing upward.
Place the Handle Sides against the Top and align the three
predrilled holes with each Side. Loosely secure each Side
to the Top using three Wood Screws. Position the Handle
Tube between the installed Sides. Insert a Cap Screw
into each Tube end and carefully thread into the Handle.
Finally, tighten all Screws.
NOTE:.The.Top.Shelf.is.symmetrical.
3 /
4
” Wood Screw.
325-5106-00
1 /
4
-20 X 2” Handle Cap Screw.
325-5034-00
Cap
Screws
Wood
Screws
Handle Side-X
Top Shelf
Handle Side-Y
Handle Tube
04
14
13