Anthro Elevate II Adjusta Assembly Instructions - Manual (Page 4)

4 Questions? Call us at 800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
STEP 1 - ATTACH GUSSETS TO TOP
ƒ Lay the top surface upside down on a cushioned, non-marring surface. Locate
the front edge of the table. On Plus tables, the front of the table has a sloping
waterfall edge. On the Basic tables, the back edge of the table has the seam
where the edgebanding meets.
ƒ Align the Leg Gussets with the holes on the top so the upright flange faces the
outside of the table and the tapering end points to the front of the table.
ƒ Attach each gusset to the top with six 1" MDF Screws using the Anthro driver.
Front
1” Button Hd PB Screw
325-5580-00
STEP 2 - INSTALL LEGS
ƒ Align one Leg with one Leg Gusset so the cord feeds out of the Leg
toward the center of the table. The Leg will rest on top of the Gusset's
button-head screws, so it may feel a little wobbly. [A]
ƒ Slide a Leg Housing over the Leg and down until it covers the Leg
Motor and the six screw holes on the housing line up with the six pre-
drilled holes on the shelf. [B]
ƒ Move to the front of the table and attach the front of the Housing to
the Leg with two M6-10MM Button Hd Screws (325-5503-00) using
the Anthro driver. Tilt the leg slightly to align the holes. [C]
ƒ Loosely attach the Housing to the shelf with six 1" Button Hd PB
Screws (325-5580-00). [D]
ƒ Attach the side of the Leg to the Leg Gusset with two M6-14 Flat-head
Screws (325-5435-00). [E]
ƒ Repeat for the other Leg and Housing.
A
B
M6-10 Button-head Screw
325-5503-00
C
D
1” Button Hd PB Screw
325-5580-00
M6x14 Flat Hd Screw
325-5435-00
E