Boltek RLO-10 Relay Interface For LD-250 - Manual (Page 3)

©2012 BOLTEK CORP RLO-10 LD-250 Install Instructions 20121002
The other end of the ribbon cable
connector at the rear of the LD-250
should be facing upwards as shown.
Replace the LD-250 top cover and secure it
by replacing the four cover screws.
Peel the paper backing from the double-
sided tape on the bottom of the RLO-10
relay unit. Stick the relay unit to the top
cover of the LD-250 as shown. Plug the
ribbon cable connector on the RLO-10 as
shown.