Boltek Lightning/2000 - Manual (Page 162)

L I G H T N I N G / 2 0 0 0
162 162 162 162
XP), this button can be checked, otherwise it will be grayed
out. If you are running under Windows 2000 or Windows XP, you
must install the device driver located in the Lightning/2000
directory. Failure to install this driver first will result in
unpredictable behavior of the program. See chapter 2 for
device driver installation instructions.
StormTracker (PCI)
If you are using the StormTracker PCI card, check this box.
Click the OK button on this dialog to complete the selection
of the PCI hardware. If the hardware is not installed
correctly, you will not be able to exit this dialog.
Before you can use the PCI card, you must first install the
device driver for the card. The installer for the device driver
may be downloaded from the Boltek website. The installer
for the device driver is also found on the Lightning/2000
installation CD.
LD-250
Check this box to use the input from the portable LD-250
unit. You will need to choose the serial port to which the
LD-250 is connected in order to detect lightning. Use of the
LD-250 is supported under all operating systems. No special
device drivers are required.
LD-350
Check this box to use the input from the portable LD-350
unit. Use of the LD-350 is supported under all operating
systems. The required driver should have been installed
automatically when the unit is first plugged into your
computer.
Flip channels
The original device driver for the PCI card accidentally
reversed the "channels" of data coming from the antenna.