Brocade Network OS Software Licensing Guide v4.1.0 User Manual
Page 26
NOTE
After adding an FCoE or DPOD license, you must disable and re-enable all affected ports. The
VCS Fabric license does not require re-enabling.
You can disable and then enable each affected port, or you can enter the chassis disable
command followed by the chassis enable command to re-enable the entire chassis.
switch# chassis disable
switch# chassis enable
3.
If the license does not appear in the show license command output, then it was not installed. In
privileged EXEC mode, enter the license add lictstr command to install the license. For FCoE
and DPOD licenses, you must also disable and enable the switch or port.
switch# license add licstr "*B
slSETgzTgeVGUDeQR4WIfRx7mmXODdSwENoRGEnAmX3Ca3uHeZgXK0b,jzxyzfzKLrMsPN8ClSxvDQRRT
8VyuULyyKTO0ryU6qm4s1jjiSAeV,COoedzCx1v6ycQgnYMeSVp#"
License Added [*B
slSETgzTgeVGUDeQR4WIfRx7mmXODdSwENoRGEnAmX3Ca3uHeZgXK0b,jzxyzfzKLrMsPN8ClSxvDQRRT
8VyuULyyKTO0ryU6qm4s1jjiSAeV,COoedzCx1v6ycQgnYMeSVp# ]
For license change to take effect, please disable/enable port or switch...
switch# chassis disable
switch# chassis enable
Licensing Tasks
24
Network OS Software Licensing Guide
53-1003164-01