Brocade ICX 6430-C Compact Switch Hardware Installation Guide - Manual (Page 32)

FIGURE 15 Attaching the logo side of the magnet sheet to the bottom panel of the ICX 6430-C device
NOTE
Do not install the rubber feet or remove the rubber feet if they are already installed.
Mounting the device on a metal surface or metal wall
NOTE
When mounting the device on a vertical metal surface, Brocade recommends that you mount the
device with the port side down.
Complete the following steps to securely mount an ICX 6430-C device on a metal surface or metal
wall:
Mounting the device on a metal surface or metal wall
30 Brocade ICX 6430-C Compact Switch Hardware Installation Guide
53-1003080-01