Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 107)

Brocade Virtual ADX Graphical User Interface Guide 95
53-1003242-01
Health checks
7
The Advanced tab is displayed, as shown in Figure 79 .
FIGURE 79 Configuring advanced parameters
5. Provide the following information:
• Use Master Port Health Check: Select the Enable check box for the usage of master port
health check.
• Fast Port Bringup: Select the Enable check box to increase the speed of the bringup
process by sending more health checks at a time.
• L4 Interval: Specify the interval at which the Brocade Virtual ADX must perform the Layer 4
check. The range is from 1 through 120 seconds. The default is 5 seconds.
• L7 Interval: Specify the interval at which the Brocade Virtual ADX must perform Layer 7
health check. The range is from 1 through 120 seconds. The default is 5 seconds.
• Retries: Enter the number of retries. The range is from 1 through 5. The default is 2.
6. Click Apply to save your entries.
Click Reset to revert the configuration to the previous configured values.
To modify the configured port profiles, in the summary table, select an entry and click Edit or
double-click the entry. You can also delete a configuration by clicking Delete. However, you
cannot edit or delete port profiles if they are in use.
For more information on configuring port profiles, refer to the Brocade Virtual ADX Server Load
Balancing Guide.
Creating a port policy
Server port policies help to reduce the configuration required for health checks and provide more
flexibility while configuring health checks.
To create a port policy on the Brocade Virtual ADX, perform the following steps within the Configure
tab.
1. Click Traffic on the menu bar.
2. From the sidebar, select Health Checks, and then select Port Policies.