Addonics Technologies HS HDD DUPLICATOR PRO HD9SITDRHS - Manual (Page 9)

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
12-03. Compare Firmware
Used to confirm correct firmware. Connect a drive formatted as FAT
containing one partition with the firmware file in the root directory.
NOTE: This function scans the entire disk before proceeding. Providing
a drive that is as small as possible is strongly recommended.
12-04. Quick Erase HDD
Scans the ports, then quickly erases all sectors on all connected drives.
12-05. Full Erase HDD
Scans the ports, then completely erases all sectors on all connected
drives.
12-06. H/W Diagnostic
Starts comprehensive tests for Ram, LCD, buttons, ports and Flash.
12-07. Load Default
Resets all configuration settings to default.
12-08. Copy HPA
Enables copy functions to duplicate the source drive's Host Protected
Area. Normally this area is defined as not available to a host controller
as defined by ATA/SATA specifications.
12-09. Burn In
Runs a function continuously until aborted. Selections are Copy &
Compare, Compare, Async Cpy & Cmp, Async Compare.