Atmel CAMELIACOL 2.5M - Manual (Page 6)

CAMELIACOL 2.5M user guide
6/12
2.3 A NTI - BLOOMING BY CLOCKING
Anti-blooming can be activated or inhibited (see 2.5.3) :
♦
anti-blooming OFF : this position is recommended if anti-blooming is not required for the application.
♦
anti-blooming ON : anti-blooming operation reduces the pixel saturation charge. As a consequence, camera
gain must be set to 1.30x (see 2.5.3) minimum in order to reach the camera saturation level (4095 adu)
2.4 E LECTRICAL INTERFACES :
2.4.1 P OWER SUPPLY :
Voltage Current
+24V
Min : +20V ; Max : +28V 0.6A
2.4.2 DIGITAL I/O
SYMBOL I/O DEFINITION LEVEL
TRIG_ITC I Timing control :
TRIG_ITC is either an external trigger or “ integration time control ”
depending on the timing mode configurated by RS232 (see after)
operation with external trigger :
TRIG_ITC = TRIG
operation with “ integration time control ” :
TRIG_ITC = ITC
TRIG_ITC is synchronized by the camera line clock (jitter : 200 µs) LVDS
S(11..0) O Digital video output : 12 bits LVDS
FEN Frame enable :
- FEN = 0 : frame data valid : active lines
- FEN = 1 : frame data not valid LVDS
LEN O Line enable :
- LEN = 0 : line data valid : active pixels
- LEN = 1 : line data not valid LVDS
PCK O Pixel clock LVDS
SHUTTER O shutter open/close :
- during integration : shutter = 1
- during readout : shutter = 0
delay between the falling edge of shutter and the start of readout :
- 4 positions : 1ms, 5ms, 10ms, 20ms. LVDS
Note :
♦
LVDS drivers / receivers :
◊
LVDS : Low Voltage differential Signal. (EIA 644 standard). All digital I/Os are differential : (signal+,
signal-). Specifications are given for signal +.
◊
manufacturer NS
◊
driver : DS90C031TM (SO16 package)
◊
receiver : DS90C032TM (SO16 package)