Elitegroup 259IA3 User Manual v.4 User Manual
Page 12
■
■
■
■ chapter 4 upgrading your computer
4-12
Note:
If you want to remove a mini PCI card from the socket, press out on the
latches located on both edges of the socket at the same time. The card should
pop up to an angle of 30 degree.
3.
Locate 2 antenna cables with connectors. Snap the cable
onto the golden connector on the Mini PCI Wireless LAN card.
(Note: The connectors are fairly small! This may take some
maneuvering. You may want to connect the antenna cables
before inserting the wireless card into the socket. )
Mini PCI
Soc ket
Mini PCI
Wireless
Card
Connec tors
4.
Replace the System Device Cover and 6 Screw C’s.
Congratulations! You have now completed the mini PCI card
installation. During the next time the system boots to Windows,
the system will prompt for driver location. Insert the Factory
CD-ROM and point to the directory where the Wireless LAN
driver can be found. In addition to installing the driver, you may
also need to run a Setup.exe program to install the card’s utility
applications before it is fully operational.